What Are the Ways on How to Adjust Handlebar Height?

What are The Ways on How to Adjust Handlebar Height?

 

What are the ways how to adjust handlebar height? The handlebar is a very important part of your bike. Before they were invented, bikes would have a three-bar setup with hand brakes and a gear shift lever. Handlebars come in many shapes and sizes, so there is no right answer to the correct handlebar height. However, the best way to adjust handlebars is by using the bike's built-in adjustment feature which can either be located on the side of the bar or near the saddle clamp in front of your seat post.

Ways how to adjust the handlebar height
1, Loosen the pinch bolt or clamp using your fingers

Using your fingers, the first way how to adjust handlebar height is by loosening the pinch bolt or clamp. Once you have loosened the bolt, slide the handlebar in or out based on your preference. Make sure you slide the handlebar to a comfortable position; if not, you will find it very hard to ride.

2, Use an Allen wrench

The second way to adjust handlebar height is by using an Allen wrench beside your handlebars, which allows for manual height adjustment. 

3, Use a screwdriver or hex wrench

The third way to adjust handlebar height is achieved by using a screwdriver or hex wrench, a feature most bike brands offer as an optional feature that can be purchased while purchasing your bike. For this option to be used, one must first open the clamp and screwdriver and find the metal strip on which the handlebar can be screwed in or out. To do so, turn it clockwise until it comes into contact with a metal strip. Once you have found this place, use your knuckle to turn it outwards as far as possible to reach the point where you can adjust your handlebar height.

4, Use other types of adjustable items

The fourth way to adjust handlebar height is achieved by using other types of adjustable items that can be bought at your local bike shop to accommodate the height of your handlebars. However, most bike shops will first give you a small plastic shim which you should place between the frame and the clamp for it to be secured and stable. If not, there may be no space for your handlebars to slide into when it is finally adjusted.

5, Attach handlebars to your seat.

The fifth way to adjust handlebar height is by attaching handlebars to your saddle. This works especially well for bikes with a higher seat post because this option allows the saddle to move forward from its original location. However, this can be easily done by purchasing a shim or the plastic cap mentioned above. Once you have done so, slide the saddle backward and attach it to your seat post with a screwdriver or hex wrench and remove any wire that may be in between the handlebars and your grip on the bars.

6, Buy a bike with adjustable handlebars

The sixth way to adjust handlebar height is by buying a bike with adjustable handlebars. However, this can only be done by purchasing a more expensive bike as this feature is not normally seen on bikes at lower prices.

7, Make adjustments at the handlebar stem

The seventh way to adjust handlebar height is achieved by making adjustments at the handlebar stem. However, this is only possible if you can move the front wheel and seat backward or forward to raise or lower your bike's center of gravity by shifting it on its suspension. This also takes some time to do and ensure you align your wheels because if not there will be a different level of pressure which will affect how your ride feels.

Conclusion

Handlebars are an important part of your bike; adjusting the bar's height allows for a more comfortable ride every time. With all the different ways how to adjust handlebar height you can choose, there is no single wrong way to do so. Some minor adjustments may require careful attention because you may find yourself bumping your bars when riding which could hurt you. Once adjusted, balance your bike's center of gravity by swinging it back and forth until it is in a spot where you are comfortable with it.


1 comment


  • Gerald A Smith

    Fortunately, I have the Velowave adjustable “handle riser” for the Ranger. Works out great!


Leave a comment

Please note, comments must be approved before they are published

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.